Separ Filter SWK-2000 - 7 Assembly; 7.1 Selection of mounting position; 7.2 Filter installation; 7.3 Electrical connection

Dok.-Nr.: D10029.EN Rev.: 11 Page 4 of 30
Manual: Water separator / Fuel pre-filter SWK-2000
Willibrord Lösing
Filterproduktion GmbH
W. Lösing Filterproduktion GmbH • Am Walzwerk 2 • 45527 Hattingen
General information 1
1.1 Disclaimer
The preparation of this document was made as carefully as possible. However, errors can not be
excluded. Therefore, we do not take over any liability for errors or deficits in this document, nor for
any consequential damages which may arise there from.
We reserve the right to make technical changes to this document or the product described herein
without notice.
1.2 Symbols used
The following symbols are used in this document to visually emphasize important information and
warnings:
Note
Note on special tips and other helpful or important information.
Attention
Disregarding these instructions may damage the fuel filter or the mashine where the
filter is mounted.
Disposal
Note on special measures for protection of the environment / surroundings and
disposal of the system or parts of the system.
1.3 Safety instructions
Wear goggles
Wear
protective
gloves
Ventilate the
work area
Refrain from
smoking
No open fire
No food in the
work area
Works on the system have to be performed by trained personal only and in compliance with the
applicable work safety regulations. Generally operate on a cut-off, voltage-free system.