Separ Filter SWK-2000 - Characteristics; Dimensions and Weights

Dok.-Nr.: D10029.EN Rev.: 11 Page 12 of 30
Manual: Water separator / Fuel pre-filter SWK-2000
Willibrord Lösing
Filterproduktion GmbH
W. Lösing Filterproduktion GmbH • Am Walzwerk 2 • 45527 Hattingen
4.2 Dimensions and weights
SWK-
2000/5
SWK-
2000/5/50
SWK-
2000/10
SWK-
2000/18
SWK-
2000/40
SWK-
2000/130
Width
140 mm
/WSA:
210 mm
140 mm
150 mm
/WSA:
220 mm
210 mm
290 mm
420 mm
Hight
275 mm
310 mm
340 mm
410 mm
470 mm
720 mm
Depth
90 mm
90 mm
110 mm
165 mm
250 mm
370 mm
Weight
< 2,5 kg
< 2,7 kg
< 3 kg
< 8 kg
< 15 kg
< 55 kg
Mountig holes
2 x Ø 9 mm
2 x Ø 9 mm
2 x Ø 9 mm
4 x Ø 9 mm
4 x Ø 12 mm
8 x Ø 15 mm
The dimensions of filter combinations may differ (see Chapter 5)
4.3 Characteristics
SWK-
2000/5
SWK-
2000/5/50
SWK-
2000/10
SWK-
2000/18
SWK-
2000/40
SWK-
2000/130
Flow performance
5 l/min
5 l/min
10 l/min
18 l/min
40 l/min
130 l/min
Complete interior
volume
450 ± 30 ml
700 ± 35 ml
1200 ± 50ml
3100 ± 90ml
7000 ± 200
ml
40 ± 1 l
Water-holding
capacity
120 ± 10 ml
120 ± 10 ml
240 ± 20 ml
500 ± 30 ml
1500 ± 50
ml
8,5 ± 0,5 l
Alarm on water
quantity
80 ± 10 ml
80 ± 10 ml
140 ± 20 ml
300 ± 30 ml
1250 ± 50
ml
7 ± 0,5 l
Water-holding capicity
with heater
-
100 ± 10 ml
200 ± 20 ml
450 ± 30 ml
1100 ± 50
ml
-
Alarm on water
quantity (with heater)
-
70 ± 10 ml
140 ± 20 ml
300 ± 30 ml
1) 350 ± 50
ml
2) 950 ± 50
ml
-
Max. allowable
pressure
15 bar
15 bar
12 bar
7 bar
4 bar
2 bar
Water separation
> 99 % des freien Wassers
1
Available filter units
10 µm (coated cellulose paper)
30 µm (coated cellulose paper)
30 µm (stainless steel mesh)
60 µm (stainless steel mesh)
The characteristics of filter combinations may differ (see Chapter 5)
1
The water separation was detected at W. Lösing Filterproduction GmbH based on the DIN 4020 and the
ISO-TS 16332.