116 Advanced Operations Switched PDU
Installation and Operations Manual
LDAP
The Switched PDU family of products supports Lightweight Directory Access Protocol (LDAP), version 3. This support
enables authentication with LDAP servers; user accounts do not need to be individually created locally on each device.
This allows administrators to pre-define and configure (in each product, and in the LDAP server) a set of necessary
LDAP Groups, and access rights for each. User’s access rights can then be assigned or revoked simply by making the
user a member of one-or-more pre-defined LDAP Groups on the PDU. User accounts can be added, deleted, or
changed in the LDAP server without any changes needed on individual PDU products.
LDAP support has been tested in the following environments:
Microsoft Active Directory (MSAD)
Novell eDirectory (eDir)
OpenLDAP
LDAP Command Summary
Command Description
Add GrouptoLDAP Grants an LDAP group access to one or more groups
Add OutlettoLDAP Grants an LDAP group access to one or more outlets
Add PorttoLDAP Grants an LDAP group access to one or more serial ports
Create LDAPGroup Adds an LDAP group name
Delete GroupfromLDAP Removes access to one or more groups for an LDAP group
Delete OutlettoLDAP Removes access to one or more outlets for an LDAP group
Delete PortfromLDAP Removes access to one or more serial ports for an LDAP group
List LDAPGroup Displays all accessible outlet/groups/ports for an LDAP group
List LDAPGroups Displays privilege levels for all LDAP groups
Ping Verifies proper DNS configuration by name resolution
Remove LDAPGroup Deletes an LDAP group name
Set Authorder Specifies the authentication order for each new session attempt
Set DNS Sets the IP address of the Domain Name server
Set LDAP Bind Specifies the LDAP bind request
Set LDAP BindDN Specifies the user account Fully-Qualified Domain Name (FQDN) for binds
Set LDAP BindPW Specifies the user account password for binds
Set LDAP GroupAttr Specifies the user class Distinguished Name (DN) or names of groups a user is a member of
Set LDAP GroupType Specifies the data type for the Set LDAP GroupAttr command
Set LDAP Host Sets the IP address or hostname of the Directory Services server
Set LDAP Port Sets the LDAP server port number
Set LDAP UserBaseDN Sets the base distinguished name (DN) for the username search at login
Set LDAP UserFilter Sets the filter used for the username search at login
Set LDAP UseTLS Enables/disables LDAP over TLS/SSL support
Set LDAP Enables/disables LDAP support
Set LDAPGroup Access Sets the access level for an LDAP group
Set LDAPGroup Envmon Grants or removes access to environmental monitoring
Show LDAP Displays LDAP configurations
Show Network Displays network configuration information for all IPv4 and IPv6 settings
To Next Page
Loading...