Server Technology Switched Rack PDU - Network Configuration Management

Switched PDU
Installation and Operations Manual Operations  31
Configuring the web session (Web Interface) timeout:
Enter a timeout period (in minutes) in the Web Session Timeout field.
The valid timeout range is 1 to 1440 minutes (24 hours); the default is 5 minutes.
Enabling/Disabling StartUp Stick

:
StartUp Stick is a Server Technology tool for mass configuration of PDU operating parameters.
Select Enabled or Disabled from the StartUp Stick drop-down menu and click Apply.
Creating a descriptive unit name:
Click on the Tower Names link.
On the subsequent Tower Names page, enter a descriptive name and click Apply.
Creating a descriptive input feed name:
Click on the Input Feed Names link.
On the subsequent Input Feed Names page, enter a descriptive name and click Apply.
Creating a descriptive outlet name:
Click on the Outlet Names link which will open the Outlets configuration page. For more information about creating
descriptive outlet names, see the “Outlets” section.
Creating a descriptive serial port name:
Click on the Serial Port Names link which will open the Serial Ports configuration page.
Creating a descriptive environmental monitor name:
Click on the Environmental Monitor Names link.
On the subsequent Environmental Monitor Names page, enter a descriptive name and click Apply.
Creating descriptive sensor names:
Click on the Sensor Names link.
On the subsequent Sensor Names page, enter a descriptive name and click Apply.
Network
The Network configuration page allows the administrator to maintain the network interface by determining IPv6 and
IPv4 status, network state, IP address, gateway, subnet mask, primary/secondary DNS addresses, and the necessary
settings and options for DHCP.
NOTE: For maximum backward compatibility, the default network mode is “IPv4 only”.