Server Technology Switched Rack PDU - Administration Commands; User Administration

Switched PDU
Installation and Operations Manual Operations  61
Displaying UPS status:
The UPSStat command displays the status of one or more UPS devices associated with the PDU.
The display includes UPS index number, type, line/battery status, and reported voltage.
NOTE: Access to this command requires enabling user privileges for environmental monitoring using the Set User Envmon command.
To display status of one or more UPS devices:
At the Switched CDU: prompt, type upsstat and press Enter.
Example
The following command displays the UPS status:
Switched CDU: upsstat<Enter>
UPS UPS UPS UPS
Index Type Status Voltage
1 Generic(RFC1628) N/A N/A
2 Liebert On Battery 120.0
3 MGE On Utility 119.9
Administration Commands
Administration commands can only be issued by a user with administrative privileges, such as the predefined Admn
user or another user who has been granted administrative privileges with the Set User Admnpriv command.
User Administration
Creating a user account:
The Create User command creates a user account with the specified username and password. See Usernames and
Passwords in this chapter for more information.
To create a user account:
At the Switched CDU: prompt, type create user, optionally followed by a 1-16 character username (Spaces are not
allowed, and usernames are not case sensitive). Press Enter.
At the Password: prompt, type a password of 1-16 alphanumeric and other typed characters - (ASCII 33 to 126
decimal) are allowed; passwords are case sensitive. Press Enter.
At the Verify Password: prompt, retype the password. Press Enter.
Example
The following command creates the user account JaneDoe:
Switched CDU: create user JaneDoe<Enter>
Password: <Enter>
Verify New Password: <Enter>
For security, password characters are not displayed.
Removing a user account:
The Remove User command removes a user account.
NOTE: You can remove the default user account admn only if you have already granted administrative access to another user account
using the Set User Admnpriv command.
To remove a user account:
At the Switched CDU: prompt, type remove user, optionally followed by a username. Press Enter.