Server Technology Switched Rack PDU - Operations Commands

56  Operations Switched PDU
Installation and Operations Manual
Administrative Command Summary (continued…)
Set Tower 3Phase Specifies the AC voltage type for the tower
Set Tower Model Specifies the model number for the tower
Set Tower Name Specifies a descriptive field for the tower
Set Tower ProdSN Specifies the serial number for the tower
Set Tower Specifies the AC or DC voltage type for the tower
Set UPS AddInfeed Adds an infeed association to a UPS
Set UPS DelInfeed Deletes an infeed association from a UPS
Set UPS GETComm Sets the UPS ‘get’ community string
Set UPS Host Sets the UPS Host IP address or hostname
Set UPS Port Specifies the target port for a UPS
Set UPS Type Sets the UPS type
Set UPS VPoll Enables or disables UPS voltage polling
Set User Access Sets the access level for a user
Set User Envmon Grants or removes user access to environmental monitoring
Set User Password Changes the password for a user
Show EnergyWise Displays Cisco EnergyWise network configuration information
Show FTP Displays FTP configuration information
Show Infeeds Displays infeed configuration information
Show Network Displays network configuration information for all IPv4 and IPv6 settings
Show Options Displays system option information
Show Outlets Displays configuration information for all outlets
Show Ports Displays serial/Pass-Thru port configuration information
Show SNTP Displays SNTP configuration information
Show System Displays system configuration information
Show System Status Displays system power and tower configuration information
Show Towers Displays tower configuration information
Show UPS Displays UPS configuration information
Version Displays the firmware version
To display the names of commands that you can execute:
At the command prompt, press Enter. A list of valid commands for the current user appears.
Operations Commands
Operations commands manage outlet states, provide information about the environment of the unit, and control
session operations.
Turning outlets on:
The On command turns on one or more outlets. When the command completes, a display indicating all outlets
affected and their current states will be displayed.
To turn outlets on:
At the Switched CDU: prompt, type on, followed by an outlet name, and press Enter, or
Type on, followed by a group name, and press Enter, or type on all and press Enter.
Examples
The following command turns the second outlet on, using the outlet’s absolute name:
Switched CDU: on .a2<Enter>
The following command turns on all the outlets in the group named ServerGroup_1:
Switched CDU: on ServerGroup_1<Enter>