122 Advanced Operations Switched PDU
Installation and Operations Manual
Setting LDAP group access level privileges:
The Set LDAPGroup Access command sets the access level privileges for an LDAP group. The PDU has four defined
access privilege levels; Admin, User, On-Only and View-Only.
To set the access level privilege for an LDAP group :
At the Switched CDU: prompt, type set ldapgroup access, followed by admin, user, ononly or viewonly, optionally
followed by a LDAP group name and press Enter.
Examples
The following command sets the LDAP group access level for LDAPAdmin to Admin:
Switched CDU: set ldapgroup access admin ldapadmin<Enter>
The following command sets the LDAP group access level for PowerUser to User:
Switched CDU: set ldapgroup access user poweruser<Enter>
Granting and removing access to environmental monitoring :
The Set LDAPGroup Envmon command grants or removes input status viewing privileges to/from an LDAP group.
To grant or remove input status viewing privileges for an LDAP group:
At the Switched CDU: prompt, type set ldapgroup envmon followed by on or off, optionally followed by a group
name and press Enter.
Example
The following command grants input status viewing privileges to the LDAP group PowerUser:
Switched CDU: : set ldapgroup envmon on poweruser<Enter>
NOTE: Granting access to environmental monitoring (temperature/humidity/sensors) to a non-admin user also grants that user access to
power monitoring (outlets, infeeds, towers – all environmental data of the PDU).
Granting and removing input status viewing privileges :
The Set LDAPGroup Envmon command grants or removes input status viewing privileges to/from an LDAP group.
To grant or remove input status viewing privileges for an LDAP group:
At the Switched CDU: prompt, type set ldapgroup envmon followed by on or off, optionally followed by a group
name and press Enter.
Example
The following command grants input status viewing privileges to the LDAP group PowerUser:
Switched CDU: set ldapgroup envmon on poweruser<Enter>
Displaying the LDAP access privilege levels:
The List LDAPGroups command displays all defined LDAP group with their access privilege level.
To display LDAP group access privilege levels:
At the Switched CDU: prompt, type list ldapgroups and press Enter.
Example
The following command displays all LDAP groups with their access privilege level:
Switched CDU: list ldapgroups<Enter>
LDAP Access Environmental
Group Name Level Monitoring
LDAPAdmin Admin Allowed
PowerUser User Allowed
User On-Only Not Allowed
Guest View-Only Not Allowed
To Next Page
Loading...