Server Technology Switched Rack PDU - Page 134

134  Advanced Operations Switched PDU
Installation and Operations Manual
Setting the number of RADIUS server retries:
The Set RADIUS Retries command specifies the number of times an authentication request is sent to the RADIUS
server. The PDU will attempt authentication with the primary server until the number of retries is reached, then will
attempt authentication with the secondary server. If the PDU does not receive a response from these attempts, the
authentication request will be rejected.
To set the number of retries:
At the Switched CDU: prompt, type set radius, followed by primary or secondary, followed by retries, followed by
the number of retries, and press Enter.
The valid retries range is 0-10; default is 2.
Examples
The following command sets the retries for the primary RADIUS server to 5:
Switched CDU: set radius primary retries 5<Enter>
The following command sets the retries for the secondary RADIUS server to 2:
Switched CDU: set radius secondary retries 2<Enter>
Displaying RADIUS configuration information:
The Show RADIUS command displays RADIUS configuration information.
To display the RADIUS configuration information:
At the Switched CDU: prompt, type show radius and press Enter.
Example
The following command displays the RADIUS configuration information:
Switched CDU: show radius<Enter>
RADIUS Configuration
RADIUS: Enabled
Auth Order: Remote->Local
Primary Server:
Shared Secret: ****
Port: 1812
Timeout: 15 seconds
Retries: 5
Secondary Server:
Shared Secret:
Port: 1855
Timeout: 5 seconds
Retries: 2