Set milliamp output parameters
Set Voltage output parameters
Set the communication type
Select measurement display units/ factor
Enter a cross-compensation error
Switch pressure compensation on/off
Set flow alarm levels
Set auto val parameters
Set calibration link
Set switch input mode
Calibrate
Calibrate the analyser
View the calibration history
View
Set Up
Calibrate
Alarm
Settings
Service
Status
Alarm
Unlatch
View
Set up
Calibrate
shortcut
Alarm
shortcut
O
O
Set up the comms parameters
Change the password(s)
Set the time and date
Change the regional settings
Adjust the display backlight timer
Adjust the display contrast
Select the security level
View the system information
Unlatch a latched measurement
View the measurement alarm status
Set up the measurement alarms
Calibrate/override milliamp outputs
Calibrate/override voltage outputs
Override relay outputs
Calibrate pressure module
Calibrate flow module
View diagnostics
View status
View status history
Key
Option/screen can be
protected by the supervisor
S
A
O
Option/screen is always
protected by the supervisor
Option/screen can be
protected by the operator
mA output
Volt output
Comms Type
Unit selection
X-interface
Pressure
Flow Alarm
Auto val
Calibration
Switch inputs
S
S
S
S
S
S
S
S
Calibrate
View history
S
Settings
Comms parameters
Password
Clock
Regional
Backlight
Contrast
Security
Information
S
S
S
A
A
Service
mA output
Volt output
Relay
Pressure
Flow
Diagnostics
S
S
S
S
S
Status
Active
View history
S
S
To Next Page
Loading...
Need help?
General
