Need help?Do you have a question about the Servomex SERVOPRO FID and is the answer not in the manual?
General| Technology | Flame Ionization Detection (FID) |
|---|---|
| Power Supply | 100-240 VAC, 50/60 Hz |
| Enclosure Rating | IP65 |
| Target Gas | Hydrocarbons |
| Detection Limit | <0.1 ppm |
| Calibration | Automatic or manual |
| Outputs | 4-20mA, RS232 |
| Applications | Process monitoring, emissions monitoring |
| Mounting | Wall or rack mount |
| Response Time | T90 < 5 seconds |
Highlights important safety information including WARNINGs and CAUTIONs for safe operation.
Details the analyser's physical dimensions, weight, electrical supply requirements, and gas flow rate specifications.
Details the analyser's performance specifications, including display indication, standard ranges, resolution, accuracy, repeatability, and drift.
Explains how to navigate menus using the keypad, enter values, and switch between modes.
Details how to set important parameters via General, Parameters, and Ethernet configuration menus.
Explains the diagnostic menu for troubleshooting, grouping sensor signals like pressure, temperature, and detector signal.
Guides the user through the calibration process, including setting zero and span values and performing calibration.
Provides safety warnings and step-by-step instructions for installing and powering on the SERVOPRO FID.
Covers electrical installation, including mains power connection, safety precautions, and EMC requirements.
Explains the importance and procedure for calibrating the analyser, including gas connection and stabilization.
Details various system errors, their causes, and implications, such as flow deviations, temperature issues, and regulator problems.
To Next Page
