SERVOPRO FID Online Total Hydrocarbons Analyser
SERVOPRO FID 01000001A rev:5 18
3 UNPACKING THE SERVOPRO FID
1. Remove the SERVOPRO FID and any other equipment from its packing.
2. Remove the wrapping plastic.
3. Remove protective caps from inlets.
4. Remove protective cap from exhaust.
5. Inspect the SERVOPRO FID and other items supplied, and check that they are
not damaged. If any item is damaged, immediately contact Servomex or your
local Servomex agent.
6. If you do not intend to use the SERVOPRO FID immediately:
o Refit protective caps on inlets and exhaust.
o Place the SERVOPRO FID and any other equipment supplied back in
its protective packing.
o Store the SERVOPRO FID as described in Section 8.
Otherwise, read section 4 (User Interface), then continue at Sections 5
onwards to install, set up, and use the SERVOPRO FID.
Retain the shipping documentation and packaging for future use (for
example, return of the SERVOPRO FID to Servomex for servicing
You must remove the protective covers as specified in Steps 3 and 4 above
before you use the SERVOPRO FID. If you do not, you may damage the
SERVOPRO FID when you try to pass gases through it.
To Next Page
Loading...
Need help?
General
