2
Table of Contents
1.0 Introduction .................................................................................................................... 3
2.0 Connecting a transducer to the DATUM 2000™ .......................................................... 4
2.1 Transmitters (2 wire devices) ...................................................................................4
2.2 Transducers (3 wire or 3 terminal devices) ............................................................. 4
2.3 Transducers (4 wire or 4 terminal devices) ............................................................. 5
3.0 Operating notes ..............................................................................................................7
3.1 OvEr and UndEr messages........................................................................................7
3.2 Sampling rate ...........................................................................................................7
3.3 Locking onto a channel ............................................................................................ 7
3.4 Displaying both channels .........................................................................................7
3.5 Manometer analog output ........................................................................................ 7
3.6 Rapidly changing input signal .................................................................................. 7
3.7 Test mode .................................................................................................................. 7
4.0 User setups ....................................................................................................................8
5.0 Set “offset” ..................................................................................................................... 9
6.0 HI/LO alarm setpoints..................................................................................................11
6.1 Alarm output ............................................................................................................ 12
7.0 Installation of pressure ttings for the manometer ................................................... 13
8.0 Calibrating the Datum 2000™ ......................................................................................14
8.1 Calibrating the Datum 2000™using known pressures ..........................................14
8.2 Calibrating the Datum 2000™using an external reference voltage ....................... 15
8.3 Calibrating the DATUM 2000™ for a transducer using the internal
reference voltage .....................................................................................................15
8.4 Calibrating the Datum 2000™ for a transmitter using the internal
reference voltage ................................................................................................ 16
9.0 Calibrating voltage input and current input ................................................................18
10.0 Erasing calibration in a channel ................................................................................21
11.0 DATUM 2000™ manometer specications ...............................................................23
12.0 DATUM 2000™ meter and manometer specifications .............................................24
13.0 Panel mount instructions ..........................................................................................25
14.0 “FCC waring” ..............................................................................................................27
15.0 Return instructions ....................................................................................................28
16.0 Limited warranty and limitation of liability ...............................................................28