Home
Setra Systems
Measuring Instruments
DATUM 2000
Setra Systems DATUM 2000 User Manual
5
of 1
of 1 rating
28 pages
Give review
Manual
Specs
To Next Page
To Next Page
Loading...
D
A
TUM 2000
™
Operating Instructions
Setra Systems, Inc.
159 Swanson Road, Boxborough, MA 01719
800.257.3872 • www
.setra.com
2
Table of Contents
Default Chapter
2
Table of Contents
2
1 Introduction
3
2 Connecting a Transducer to the DATUM 2000
4
Transmitters (2 Wire Devices)
4
Transducers (3 Wire or 3 Terminal Devices)
4
Transducers (4 Wire or 4 Terminal Devices)
5
3 Operating Notes
7
Over and under Messages
7
Sampling Rate
7
Locking Onto a Channel
7
Displaying both Channels
7
Manometer Analog Output
7
Rapidly Changing Input Signal
7
Test Mode
7
4 User Setups
8
Set "Offset
9
5 0 Set “Offset”
11
6 HI/LO Alarm Setpoints
11
Alarm Output
12
7 Installation of Pressure Fittings for the Manometer
13
8 Calibrating the Datum 2000
14
Calibrating the Datum 2000™Using Known Pressures
14
Calibrating the Datum 2000™Using an External Reference Voltage
15
Calibrating the DATUM 2000™ for a Transducer Using the Internal Reference Voltage
15
Calibrating the Datum 2000™ for a Transmitter Using the Internal Reference Voltage
16
9 Calibrating Voltage Input and Current Input
18
10 Erasing Calibration in a Channel
21
11 DATUM 2000™ Manometer Specifications
23
12 DATUM 2000™ Meter and Manometer Specifications
24
13 Panel Mount Instructions
25
FCC Waring
27
Return Instructions
28
Limited Warranty and Limitation of Liability
28
5
Based on 1 rating
Ask a question
Give review
Questions and Answers:
Need help?
Do you have a question about the Setra Systems DATUM 2000 and is the answer not in the manual?
Ask a question
Setra Systems DATUM 2000 Specifications
General
Brand
Setra Systems
Model
DATUM 2000
Category
Measuring Instruments
Language
English
Need help?
General
To Next Page