30
Setra Super Count
TM
Operator's Manual
Appendix II
Setup Functions
PRINT FORMAT
The print format setup controls the printout of various measured and stored numbers. You may setup
the scale to have two different print formats for printing labels:bar code labels and/or for English
(human readable) printing. In addition, ten custom print formats are available using the ScriptCoder
feature. (See Section V, ScriptCoder Custom Label Printing for details.)
The key sequence — 1111 may be formatted for bar code or English (human readable) labels and
determines the printing device and specific data that shall print when the print key is pressed. The
key sequence — 4444, (also referred to as ALTERNATE PRINT) may also be formatted for bar code or
English labels, and determines the printing device and specific data that shall print when the • print
keys are pressed. To format the information to be printed, use the following procedure:
1. Press the — key.
2. Enter 1111 or 4444.
3. Press the setup/cal key. The display will read “SEt Pr.”
4. Enter 0 if you are going to program the scale using the ScriptCoder feature. Refer to Section V
for programming instructions or the ScriptCoder operator’s manual available with ScriptCoder
Label Design & Cable Kit (Setra P/N 404910).
Enter 1 if it is connected to a Dymo Setra 300 printer with paper; press the setup/cal key and
continue to step #6.
Enter 2 if it is connected to a Setra Auto Count™ 200 bar code printer option; press the setup/
cal key. The scale’s print format is now set and this procedure is complete.
Enter 3 if it is connected to a Dymo Setra 300 printer with labels; press the setup/cal key and
continue to step #5.
If you are not using a Setra printer or Setra Auto Count see ‘NOTE: c’ at the end of this setup to
determine which number (0, 1, 2, or 3) is most appropriate for your system configuration.
Press clear if you do NOT wish to proceed.
5. For option 3, the display will read “LinES”. The scale now asks how long the labels will be,
measured in terms of lines (for most printers 6 lines = 1 inch). For the Dymo Setra 300 printer,
enter 0 and setup/cal to enter a formfeed command. For other printers, to determine the num-
ber of lines, measure with a ruler the distance from the top of one label to the top of the next
label in inches and multiply by six. Enter this value and press the setup/cal key.
Regardless of the number of lines of information to be printed, the Super Count will advance
the printer the same preset distance each time. CAUTION: The scale will not print more lines of
information than the number entered in this step.
6. Read the display. The scale now asks if you wish to print the “TARE” weight.
To Next Page
Loading...
Need help?
General
