Setra Super Count
TM
Operator's Manual 25
MULTIPLE IDENTICAL LABELS
The Super Count scale can be programmed to print the same label up to nine times with or without
sequential numbering (see ScriptCoder for sequential numbering). To print multiple identical labels,
perform the following steps on the scale keypad:
1. Press the setup/cal key followed by the script’s identifying number, and then the print key. (For
example, setup/cal, 1, print.)
2. The display will read “LAbELS”. Enter a number (1-9). The scale will immediately begin printing
the number of labels entered.
The scale will then return to printing single labels which can be accessed by entering the script
identifying number followed by the print key.
INTERFACING WITH A COMPUTER
The Setra Super Count is designed to interface with a wide variety of computer equipment. If your
scale is connected to a computer, transmit information to the computer by following the instructions
given for “Printing Out Information.” For further details, see Appendix VI.
To Next Page
Loading...
Need help?
General
