36
Setra Super Count
TM
Operator's Manual
SETTING THE TIME AND DATE
Your Setra Super Count scale may be equipped with an optional time/date feature. If this option has
been installed, set the time and date using the following procedure:
1. Enter —9999.
2. Press the setup/cal key. The display will read “00-99”.
3. Enter the year, any number from 0 to 99; e.g. enter 91 if the year is 1991.
4. Press the setup/cal key. The display will read “01-12”.
5. Enter the month, from 1 to 12; e.g. enter 6 for June.
6. Press the setup/cal key. The display will read “01-31”.
7. Enter the day, from 1 to 31; e.g. 25 for the twenty-fifth.
8. Press the setup/cal key. The display will read “00-23”.
9. Enter the hour, in 24 hour time; e.g. 12:00 PM (noon) is 12, 11:00 AM is 11, 3:00 PM is 15, 11:00
PM is 23, 12:00 AM (midnight) is 0, etc.
10. Press the setup/cal key. The display will read “00-59”.
11. Enter the minutes, from 0 to 59.
12. Press the setup/cal key.
NOTE: If your scale does not have the time/date stamp option, it will ignore the command — 9999
setup/cal.
SETTING DISPLAY UPDATE RATE (INT MODE)
The Setra Super Count scale automatically adjusts the update rate of the displayed information to
provide optimum performance in various environmental conditions, such as vibration or draft. How-
ever, certain applications may require a fixed display update. The INT Mode is factory preset to
provide a rapid display update (short integration time) for filling pieces to a target count. The use of
this Mode can be altered to provide a slow display update (long integration time) for weighing in the
presence of draft or vibration. Follow the procedure below to change the functionality of the INT Mode
to either a slow or rapid display update:
1. Enter —11110.
2. Press the setup/cal key. The display will read “INT 1 or 0”.
3. Press 1 for a long integration time (vibration control). Press 0 for a short integration time (filling).
4. Press the setup/cal key.
To Next Page
Loading...
Need help?
General
