Appendix A • Super II 102
Receiving Data From the Scale Using the Immediate Print Mode
The immediate print command “#” causes the scale to transmit whatever number or message appears in
the scale display. The value is formatted as shown below:
+/- 1 2 3 4 5 6 . c0 c1 c2 c3 CR LF
The first six digits represent the number field. A + or - sign always precedes a weight reading, and a deci-
mal point is always transmitted, though their exact location depends on the number transmitted. Numbers
with less than six digits are preceded by spaces and the sign is always adjacent to the leading digit. The
specific location of the decimal point depends on the precision of the number transmitted.
“c0” is the speed mode character.
CHARACTER MEANING
F Scale is set to fastest speed
f Scale is set to fast speed
(space) Scale is set to normal speed
s Scale is set to slow speed
S Scale is set to slowest speed
“c1” is the “mode” character. It describes what the number being transmitted represents. The
following is a list of all possible mode characters:
CHARACTER MEANING
(space) Number field is a message or net weight
G Number field represents GROSS weight
T Number field represents TARE weight
A Number field represents APW
M Number field represents ACCUM contents
“c2” is the “units” character. It describes the units of the number being transmitted. The following is a list of
all possible characters sent in this digit:
CHARACTER MEANING
G Number is expressed in grams
O Number is expressed in ounces
P Number is expressed in pounds
Y Number is expressed in troy ounces
R Number is expressed in carats
D Number is expressed in pennyweights
K Number is expressed in kilograms
X Number is expressed in user programmable unit
C Number is expressed in pieces
To Next Page
Loading...
Need help?
General
