Supervisor Setup • Super II 17
NO FRMT GO BACK
Select Format for Interval Printing:
0. Print 0 4. Print 4 8. Print 8
1. Print 1 5. Print 5 9. Print 9
2. Print 2 6. Print 6 –. Prt Int
3. Print 3 7. Print 7
Interval Print Programming
Any of the ten print fomats can be selected for interval printing. Selecting “No Format” will send the
displayed weight or count value to the BI port. The interval print function is set up by selecting the PRINT
INTERVL soft key in the Print setup. The following display will appear:
The currently selected format as well as the Time Interval between printings is displayed. Note that the
time interval of 0.0 means that the internal print function is disabled. The interval printer will wait for the
last printing job to finish before starting the next. If a small interval is selected, the port will continuously
stream data. Select the PRINT soft key to set up the print format and the TIME soft key to select the time
between printings.
If the PRINT soft key is selected, the following screen appears:
Select one of the preprogrammed print registers using the numeric keypad, or the NO FRMT soft key to
have the scale print the weight or count in the immediate Print Mode format. (Appendix A)
If the TIME soft key is selected:
Select from either the two pre-programmed choices or, using the numeric keypad, enter a time interval
followed by the ENTER key. Once the time interval is programmed, interval printing is stopped or started
by selecting the Prt Int register through the - (minus) key in the print menu.
NOTE: The maximum output rate is every 0.2 seconds.
ENTER OFF 0.2 0.5 GO BACK
Select print interval or enter
interval time (in sec.):
Select Format or Time for Interval
Printing:
PRINT TIME GO BACK
Interval Print Format: No Format
Interval Print Time: 0.0 SEC
To Next Page
Loading...
Need help?
General
