Bases Setup • Super II 61
SETUPS
MORE
BASES
SETUP
RESOLUT
abc reset
tare
menu remote
Soft Key:
RESOLUT
Setting the Resolution of the Displayed Weight
The high resolution Setra scale comes direct from the factory set at a readability that approximates the
linearity characteristics of the scale. That is to say, after calibration, the displayed weight for any object
placed into the center of the pan should not be off by more than the displayed increment from its true
value. However, the scale is capable of detecting much smaller weight changes than those displayed as
exemplified when counting very small pieces. The RESOLUT key can be used to increase displayed weigh-
ing resolution. Likewise, if the scale is not stable due to environmental factors such as draft or vibration, the
resolution can be decreased to prevent display instability.
To access the RESOLUTION settings in the Bases Setup menu, follow the menu tree or press the keys in the
order listed below:
Press the RESOLUT soft key.
To program displayed increments, press the USER soft key. Using the numeric keypad, type in the last digit
of resolution in grams followed by the ENTER soft key.
NOTE: Only resolutions up to a maximum of the sampling resolution , typically of 1 part in 1,000,000 will
be accepted by the scale. All displayed resolutions in grams or any other unit of measure are rounded to
the closest 1, 2, or 5 digit increment. Programmed resolutions that are greater than the factory default
readability will be displayed with the last digit in reverse video as a notice to the user that the resolution is
greater than the linearity characterisitics of the scale.
To return to the scale’s default resolution which closely matches the scale’s linearity, press the DEFAULT
soft key.
To Next Page
Loading...
Need help?
General
