SFC Cessna 182Q - NORMAL (COLD) START Procedures; HOT START Procedures

CESSNA 182Q QRH
Page 7 of 33
C182Q QRH JAN 2022
NORMAL (COLD) START Procedures
1. Mixture ………………………………………………………………….…………… Full RICH
2. Propeller………………………………………………….…………………………HIGH RPM
3. Carburettor Heat……………………………………………….………………….…….OFF
4. Throttle………………………………………………………………………….OPEN ½ INCH
5. Master Switch (BATT & ALT) ………………………………………………………. ON
6. Propeller Area ………………………….………………………………………..…. CLEAR
7. Magnetos Switch ……………….…………………………………………………. START
IF ENGINE DOES NOT START WITHIN 30 SECONDS, DISENGAGE THE
STARTER, PRIME THE ENGINE AND THEN REPEAT THE START
PROCEDURE
WHEN or AFTER ENGINE STARTS AND RUNNING
8. Throttle …….……………………………………………………………… SET 1000 RPM
9. Oil Pressure (UP WITHIN 30 SEC) …………………………………………. CHECK
CAUTION:- DO NOT PUMP THROTTLES DURING START
HOT START Procedures
1. Mixture………………………………………………………………………………….Full Rich
2. Propellor……………………………………………………………….…………….High RPM
3. Carburettor Heat…………………………………………..……………………………..OFF
4. Throttle………………………………………………………………………..OPEN ½ INCH
5. Master Switch (BATT & ALT)………………..……………………………………….ON
6. Propeller Area………………………………………………………………..……….CLEAR
7. Magnetos Switch…………………………………………………………………….START
IF ENGINE DOES NOT START WITHIN 30 SECONDS, DISENGAGE THE
STARTER, PRIME THE ENGINE AND THEN REPEAT THE START
PROCEDURE
WHEN or AFTER ENGINE STARTS AND RUNNING
8. Throttle……………………………………..……………………………….SET 1000 RPM
9. Oil Pressure (UP WITHIN 30 SEC)…………………………………….………CHECK
CAUTION:- DO NOT PUMP THROTTLES DURING START