PAGE 9
PAGE 8
BEFORE USE
1. Set the ON/OFF switch to the-
OFF position (pushed down).
2. Make sure that the compressor
is on level ground and check that
the oil level is half way up the oil
sight glass
3.
4. If not, remove the breather plug
and fill with compressor oil (our
part code SO2068)
OPERATION
1. Attach a hose to the quick release coupler on the compressor and to
an air tool.
2. Turn the compressor on by lifting the on/off button. The compressor
will operate until the tank is fully pressurised before switching off. The
compressor will start again when the tank pressure drops.
WWW.SGS-ENGINEERING.COM
To Next Page
Loading...
