PAGE 11
PAGE 10
OPERATION
SWITCHING OFF
1. Push down on the on/off switch
to turn the compressor off.
2. Operate the air tool to depres-
surise the air hose.
3. Disconnect the tool from the
hose.
4. Open the drain cock to remove
any condensation from the
compressor.
3. Check the safety cut off valve is
working correctly - pull on the
ring to release air. When you
release the ring the air should
stop. If the valve does not op-
erate correctly do not use the
compressor.
4. Set the regulator to the correct
pressure for the air tool (check
in the air tool manual). The
output pressure is shown on
the right gauge. The left hand
gauge shows the tank pressure.
WWW.SGS-ENGINEERING.COM
To Next Page
Loading...
