MAINTENANCE
EMPTYING THE DUST CUP
Press the wand release button and lift the
handheld vacuum o the wand�
To remove the dust cup from the handheld
vacuum, squeeze the two Dust Cup Release
buttons at the same time and pull out the dust
cup�
To reinsert the dust cup back into the handvac,
angle the tip first and then push up until it
clicks into place�
Hold the dust cup over the bin� Press the
Empty button and pull the dust cup open�
Perform regular maintenance on the filters to keep your vacuum's suction power optimal.
IMPORTANT:
To prevent damage, rinse filters with water
ONLY
�
DO NOT
use soap� Allow filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electricparts�
Empty the dust cup each time you vacuum and periodically during cleaning, if debris in the
dust cup reaches the MAX fill line.
MAINTENANCE
CLEANING FILTERS
IMPORTANT: Unplug the vacuum before performing any maintenance� IMPORTANT: Unplug the vacuum before performing any maintenance�
NOTE: For replacement filters please visit sharkclean�co�uk
PRE-MOTOR FILTERS POST-MOTOR FILTER
REPLACEMENT FILTERS
To access the pre-motor filters, press and
pull both filter access tabs on the dust cup
to remove the filter holder� The Pre-Motor
Filters should be washed twice a month�
Remove the filter cover on the top of the
handvac to access the post-motor filter� The
Post-Motor Filter should be washed once
every 9 months�
Empty
Release
Button
Release
Button
Release
Button
Pre-Motor
Filters
Post-Motor Filter
Acces
Empty
Button
13
12
To Next Page
Loading...
Need help?
General
