MAINTENANCE
CHECKING FOR BLOCKAGES
MAINTENANCE
Remove the handheld vacuum from the wand
and check all dust cup intake openings�
Detach the wand and check it for
blockages�
CHECK HANDHELD CHECK WAND
Detach the wand, then remove the Soft Roller�
Tilt the floor nozzle tube back and check
openings for blockages� Reinsert Soft Roller
until it clicks securely into place�
Remove any blockages or debris from the floor
nozzle debris intake (See Nozzle Maintenance
section)�
CHECK FLOOR NOZZLE
NOZZLE MAINTENANCE
NOTE: For best performance, keep the Soft Roller clean with regular maintenance�
Anti Hair Wrap Technology removes hair
from your brush-roll continuously as you
vacuum� At times you may see small amounts
of hair around the brush-roll – simply
continue vacuuming and the comb and
suction will remove the hair as you clean�
To remove the cover, use a coin to turn the
locks counterclockwise� Lift o the cover
and remove any debris or hair wrap� Check
the Debris Intake and clear away any dirt or
blockages�
To close the cover, push down until it clicks
into place, then turn the locks clockwise
until closed�
CLEANING THE SOFT ROLLER
1 To remove the Soft Roller, slide the Eject Roller
button on the floor nozzle�
2 Tap loose debris o the Soft Roller� Use a dry
towel to wipe it clean, and to remove any debris
caught in the teeth behind the Soft Roller�
3
Hand-wash the Soft Roller as needed� Use only
water, and let it air-dry completely for at least
24 hours�
4
Reinsert the Soft Roller and press it in until it clicks
securely into place�
15
14
To Next Page
Loading...
Need help?
General
