6 TOLL FREE: 1-800-798-7398
Using the Accessories
Using the Combo Crevice/Dusting
Tool
:
The Combo Crevice/Dusting tool
can be attached to either one or
both extension tubes for greater
reach or directly onto the handle.
1 Remove the floor brush from
the lower extension tube and
then depending on the length
that you desire, just push it in to
the end of the extension tube or
the handle. (Fig. 7)
Using the Turbo Brush
:
The Turbo Brush can be attached to
either one or both extension tubes
for greater reach or directly onto
the handle.
1 Remove the floor brush from
the lower extension tube and
then depending on the length
that you desire, just push it in to
the end of the extension tube or
the handle. (Fig. 8)
Note: The efficiency of your Turbo
Brush depends on the bristle brush
rotating at high speed. Strong air
action is needed to accomplish this.
In order to ensure that maximum air
suction is maintained:
a Change the dust bag
frequently.
b Replace the filter as needed.
c Ensure that the rotating
brush is kept free of hair and
debris which may accumulate
and decrease brush
performance.
Cleaning the Turbo Brush
:
From time to time, the turbine
of your turbo brush will require
cleaning.
1 Remove the Turbo Brush from
the hose or extension tube.
2 Turn the Turbo Brush over and
open the hinged cover to access
the turbine wheel. (Fig. 9)
3 There may be dust, lint, hair, etc
on the turbine wheel. Remove
as much of this as possible. Use
the vacuum with the hose to
remove any additional debris
that may remain.
Fig. 7 Fig. 8
Fig. 9
EP780C_42_IB_ENG_FRE_110418_1.indd 6 11-04-19 9:15 AM
To Next Page
Loading...
