sharkclean.comsharkclean.com
MAINTENANCE
CLEANING THE ROBOT'S FILTER
Remove and empty the dust bin. Clean any hair or
debris o the back of the dust bin.
Every time you empty the dust bin, lightly tap dust
and dirt o the filter, then use a dry cloth or soft
brush to remove any remaining debris.
For optimal suction power, after each use, clean the filter inside the robot's dust bin.
CLEANING SENSORS AND CHARGING CONTACTS
CLEANING SIDE BRUSH
MAINTENANCE
Carefully unwind and remove any string or hair
wrapped around brush.
Gently wipe brush with a dry cloth. To reinstall, snap
the brush over the peg. Spin the brush manually to
make sure it is installed correctly.
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust o the sensors
and contacts located on the bottom of the robot and on the Self-Empty Base.
NOTE: Remove and replace any side brush that is bent or damaged. To remove a brush, lift it o its peg.
IMPORTANT: The robot uses cli sensors to avoid stairs and other steep drops. Sensors may work less eectively when
they are dirty. For best results, clean sensors regularly.
CLEAN SIDE BRUSH AS NEEDED.
To Next Page
Loading...
Need help?
General
