sharkclean.comsharkclean.com
CLEANING THE ACCESSORIES
MAINTENANCE
CLEANING THE FILTERS
1. Lift out the foam filter by the handle, then
pull out the felt filter.
2. Rinse both filters with cold water O N LY.
DO NOT use soap. Allow both filters to air-
dry completely before reinstalling.
3. Reinsert the felt filter first, followed by the
foam filter.
The Squeegee Tool*, Crevice Tool*, Claw
Tool*, and 3-Piece Extension Wand* should
be cleaned after picking up any wet and
organic mess.
1. Rinse the accessories in the sink with
warm, soapy water.
2. Allow accessories to air-dry completely.
1. Pull up on the post-motor filter cover to
remove it, then lift out the post-motor filter.
2. Wash the filter gently with cold water ONLY.
DO NOT use soap. Leave the filter out to
air-dry completely before reinstalling it.
3. Reinsert the post-motor filter back into the
opening, then place the cover over it and
press down until it clicks into place.
PRE-MOTOR FILTERS POST-MOTOR FILTER
Foam
Filter
Post-Motor
Filter
Felt
Filter
Regularly rinse and replace the filters to maintain your vacuum’s suction power.
The pre- and post-motor filters should be cleaned once a month and replaced
once a year for optimal performance.
IMPORTANT: DO NOT use soap when cleaning the filters.
NOTE: *DISHWASHER SAFE.
MAINTENANCE
RINSING THE LID AND DEBRIS SCREEN
IMPORTANT: Unplug the power cord before performing any maintenance.
1. Open the lid to a 180-degree angle then
pull out to detach it from the hinges.
2. Twist the debris screen counterclockwise
and pull it out.
3. Rinse the lid and debris screen in the sink with
warm water. Allow the lid and debris screen
to air-dry completely before reinstalling.
4. To reinstall the debris screen, align the
arrow in the lid with the arrow on the side
of the debris screen and twist clockwise to
the lock symbol to secure.
5. To reattach the lid, align the hinge
connection points at 180 degrees and push
until it snaps into place.
Rinse the lid and debris screen after picking up any wet or organic mess.
Post-Motor Post-Motor
Filter CoverFilter Cover