sharkclean.comsharkclean.com
MAINTENANCE
RINSING THE HOSE, LID, AND DUST CUP
Run a Rinse & Ready cleaning cycle after
picking up any wet or organic mess.
1. Empty the dust cup or remove and
dispose of the bag.
2. Vacuum up 10 oz. of water from a cup,
bowl, or other container.
3. Unplug the unit and open the lid. If any
stubborn debris remains, follow the
instructions in the Cleaning the Lid and
Debris Screen section.
EMPTYING THE DUST CUP*
Always empty the dust cup after vacuuming.
1. Open the lid, then lift out the dust cup by
the sides. DO NOT grab the dust cup by
the bag guides.
2. Dump remaining debris into the trash and
rinse out the dust cup with warm water.
3. Allow the dust cup to air-dry completely
before reinstalling it back into the unit.
NOTE: *DISHWASHER SAFE.
NOTE: You can also mix 10 oz. of water and 0.5 oz. of distilled white vinegar for the Rinse & Ready cycle.
USING YOUR MESSMASTER™
DRY VACUUMING
WET VACUUMING
HOSE INLET
BARE FLOOR TOOL CARPET TOOL PET MULTI-TOOL
SQUEEGEE TOOL
SQUEEGEE TOOL
HELPFUL TIP: SANITIZATION
CREVICE TOOL
Option 1:
Use the hose inlet
for ANY mess.
For large messes and fine debris
on bare floors.
The following dry vacuuming accessories are only included with some units.
For embedded dirt and debris
on carpet and upholstery.
For pet hair and dusting.
Option 2: For embedded pet
hair on carpet and
upholstery.
Option 3: For crevices, corners,
and other tight
spaces.
Option 1:
Use the hose inlet
for ANY mess.
1. Spray the surface with any
all-purpose cleaner.
2. Use the squeegee to vacuum
up the cleaning spray.
Option 2: For liquid residue.
HOSE INLET
IMPORTANT: Unplug the power cord before opening the lid.
To Next Page
Loading...
Need help?
General
