RECOMMENDED FILTER CLEANING SCHEDULE:
Pre-motor Filter Kit (Foam & Felt): XFF680 Every 3 months
Post Motor Filter: XHF680 Every year
EMPTY THE DUST CUP
1 Pull up on the dust cup release latch and lift the dust
cup off the pod.
2 Holding the dust cup over a rubbish bin, press the
bottom empty release latch.
3 Press the top dust cup release latch to access the dust
screen and remove built-up debris as required.
CLEAN THE FILTERS
1 With the dust cup removed, remove and rinse the foam
and felt filters every 3 months. Let air dry completely
before replacing. Hand wash only. Tap loose dirt off
filters between washes as needed.
2 Once a year open the filter grill and remove and
rinse the HEPA filter. Let air dry completely before
replacing. Hand wash only.
WARNING: DO NOT PICK UP FIREPLACE ASH
OR DRYWALL DUST.
MAINTENANCE
To keep your vacuum’s suction power optimal, follow these instructions.
Make sure unit is off and cord unplugged.
IMPORTANT: Allow ALL filters to dry completely before replacing into the vacuum.
STEP 1 STEP 2 STEP 3
HEPA
FELT FILTER
FOAM FILTER
FILTER FRAME
To Next Page
Loading...
Need help?
General
