MAINTENANCE
To keep your vacuum’s suction power optimal, follow these instructions.
Make sure unit is off and cord unplugged.
CHECK FOR BLOCKAGES
1 Use a coin to unlock the 3 locks on the
bottom of the floor nozzle.
2 A portion of the base is removable to
allow for better access to the brush
roll and exposure to the airway. Shine
a torch from the bottom to check for
possible blockage in the airway.
3 Remove any string, carpet fibers or
hair that may be wrapped around
the brush roll. There is a groove on
the brush bar that allows a pair of
scissors to cut across it to loosen
up the debris.
4 To reassemble, replace base by
lining it up along the front of the
nozzle. Push down to snap into
place. Lock the 3 locks.
STEP 1 STEP 2 STEP 4STEP 3
To Next Page
Loading...
Need help?
General
