31
8. Taper Attachment
Installation Taper of Attachment:
STEP1:
Install taper attachment on the carriage using screws NO.○
31
via hole “A”
(Don’t tighten too tight using screw M10x40L and flat washer.)
STEP2:
Disengaged screw NO.○
8
STEP3:
Adjust the position of NO.○
1
and let are gage point is contacted with
NO.206009.
STEP4:
Set a dial gage on the NO.○
19
, and gage point is contacted the surface of bed.
Moving NO.○
19
, pointer has to be constant lifit's not, adjusting the position of
NO.○
1
.
STEP5:
Disengaged screw NO.206010 then locked NO.206009 to NO.○
7
STEP6:
Replaced screw NO.○
8
STEP7:
Drill B hole. (Using Ø 6m/m driller)
STEP8:
Set straight pin. (Ø 6x45l)
STEP9:
Install universal connected-rod.
To Next Page
Loading...
