7
2
Follow the installation procedure below to use the unit properly.
SETUP PROCEDURE
When using the unit for the first time, setup the unit following the procedure shown
below.
* If you are only using the unit for copying, skip this step.
If the unit does not function properly during setup or use, or if a function
cannot be used, see "TROUBLESHOOTING THE UNIT" (p.62).
1 Open the package, and make sure that all the accessories are
supplied with the unit. (p.8)
2 Remove the protective materials. (p.9)
8 Now, you can copy (p.46), print (p.35) or scan (p.36) your
document.
3 Install the TD cartridge. (p.10)
4 Load the paper in the paper tray (p.15) or the multi-bypass
tray
. (p.17)
5 Plug the other end of the power cord into the nearest outlet. (p.12)
6 Install the software.* (p.19)
7 Connect the interface cable* (p.25) and turn on the unit. (p.12)
2
SETTING UP THE UNIT
To Next Page
Loading...
