Other
viewing
options
Allows you to capture and freeze
an
image from a
moving image that you are watching.
FREEZE
MENU
.~O
8@8
EXIT
~
RETURN
O~O
- FAVORITE CH -
0---®---@---@
Press FREEZE.
• A moving image is captured.
Press FREEZE again to cancel the
function.
You can operate the connected AV products (AV
Receiver, Cable Box, SAT tuner, DTV, VCR, DVD,
LD) using the presetting manufacturer function of your
remote control unit.
TV
TV VCR AUDIO
goo
0
"'~~
CBLlSAT
DVD
FUNCTION
pO
0 0
(I)
SOURCE
LIGHT
8
rn
8
CB
(3
REC
C!J
0
0
8)
(3
@ID
MODE
• When this function is not available, "NOT AVAILABLE"
will display.
• The still image automatically goes out after
30
minutes.
• If you are using the freeze function and a broadcast
activates the V-CHIP block, the freeze function will be
cancelled and a V-CHIP block message will appear.
@
INPUT
FLASHBACK
00
Presetting
manufacturer
codes
In
order to receive digital air broadcasts, you need a
digital broadcast antenna. You can confirm the antenna
configuration through the "SIGNAL METER" menu.
Press FUNCTION until the LED for your
device lights up.
After the LED for your device lights up,
press FUNCTION and DISPLAY at the
same time to enter the code registration
mode. The LED will blink.
Press
0-9
to enter the manufacturer code.
(See page 38.)
• Preset mode is finished once the LED no
longer lights up.
After registering the code, the LED will stop
blinking then turn off after one second. (If
you perform
an
incorrect operation, the LED
will blink quickly then turn off.)
CHANNEL
(DIGITAL)
23.002
~
•
40
SIGNAL
METER
Press
~/~
to select r (SETUP).
Press
<llllIII/~.
• The strength of the digital signal is displayed.
The signal information is based
on
the current
channel.
Press
lit..!'"
to select "SIGNAL METER".
Press EXIT to return to the normal screen.
If necessary, adjust the direction of the antenna to
obtain the maximum signal strength.
Signal
strength
Press MENU and the MENU screen
displays.
@-37
To Next Page
Loading...
