Sharp AQUOS LC-32D77X

30
Watching TV
Auto power-off at a designated time
This function is conveniently used when, for instance,
going to bed while watching TV.
1
2
Sleep Timer: Remain 2 hr. 00 min.
Press SLEEP.
• Remaining time displays when sleep timer has
been set.
Each time you press SLEEP, the remaining
time switches as shown below.
0 hr. 30 min. 1 hr. 00 min. 1 hr. 30 min.
2 hr. 30 min. 2 hr. 00 min.
Off
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “ECO”.
• ECO menu displays.
2
Press
a
/
b
to select “No operation off”, and
then press ENTER.
3
Press
a
/
b
to select “30min.” or “3hr.”, and
then press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
4
NOTE
• “Disable” is the factory preset value.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “ECO”.
• ECO menu displays.
2
Press
a
/
b
to select “No signal off”, and then
press ENTER.
3
Press
c
/
d
to select “Enable”, and then press
ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
4
NOTE
• “Disable” is the factory preset value.
• When a TV programme finishes, this function may not
operate.
Auto power-off after the end of broadcast
You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving no
programme signals, such as the end of a broadcast day.
Energy conservation settings
Quick start
You can reduce the TV’s start-up time after turning on
the power with the remote control unit.
Press a/b to select “Quick start”, and then
press ENTER.
3
Press c/d to select “On” or “Off”, and then
press ENTER.
4
Press MENU and the MENU screen displays.
1
Press c/d to select “Setup”.
2
Selected item Description
On The TV quickly starts up from standby,
22 W or more of power consumption is
required during standby.
Off Power consumption is less than 1 W.
NOTE
• The sleep timer indicator on the TV lights up when the time
has been set.
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.
• Select “Off” by pressing SLEEP to cancel the sleep timer.
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “ECO”.
• ECO menu displays.
2
Press
a
/
b
to select “Energy save”, and then
press ENTER.
3
Press
a
/
b
to select “Standard” or
“Advanced”, and then press ENTER.
4
Energy save
This function enables you to automatically reduce the
backlight brightness in order to decrease the power
consumption and increase the backlight life span.
Selected item Description
Standard
Reduces the backlight brightness by 25%.
Advanced Reduces the backlight brightness by 50%.
Off The backlight brightness is the same value
of your settings in the selected “AV MODE ”.
52D77X.indb 3052D77X.indb 30 2/17/09 5:13:21 PM2/17/09 5:13:21 PM