Sharp AQUOS LC-32D77X

On Off
Auto power on
AQUOS LINK control
Selecting recorder
Using genre info.
Setting auto power on by AQUOS LINK
51
Repeat steps 1 to 3 in AQUOS LINK control.
1
Press
a
/
b
to select “Selecting recorder”, and
then press ENTER.
2
Select the recorder, and then press ENTER.
3
Selecting recorder
Here, you can select a recorder for the recording from
several connected recorders.
AQUOS LINK
Press MENU to exit.
4
AQUOS LINK control
Auto power on
Selecting recorder
Using genre info.
Input Location
INPUT1
INPUT2
[1. 0. 0. 0]
[2. 0. 0. 0]
Selecting recorder for recording
by [REC] button
NOTE
• If you have connected the AQUOS AUDIO speaker system
between the TV and an AQUOS Recorder, the external
source’s indication changes (e.g. from “INPUT 1” to
“INPUT 1 (Sub)”).
Auto power on
Selecting recorder
Using genre info.
Input Location
INPUT1
INPUT1 (Sub)
INPUT2
[1. 0. 0. 0]
[1. 1. 0. 0]
[2. 0. 0. 0]
Selecting recorder for recording
by [REC] button
AQUOS LINK control
Repeat steps 1 to 3 in AQUOS LINK control.
1
Press
a
/
b
to select “Using genre info.”, and
then press ENTER.
2
Press
c
/
d
to select “On”, and then press
ENTER.
3
Using genre info.
This function allows you to automatically switch to
the appropriate sound mode depending on the genre
information included in the digital broadcast.
Operating an AQUOS LINK device
AQUOS LINK allows you to operate the HDMI-
connected device with a single remote control unit.
Press PLAY
I
to start playback of a title.
• See page 52, section “Playback of titles using
AQUOS LINK” if you want to start playback using
the list of the titles of the AQUOS BD Player/
AQUOS Recorder.
2
Press FWD
J
to fast forward.
Press REV
G
to reverse.
Press STOP
H
to stop.
Press POWER to turn the HDMI-connected
device on/off.
3
Press
a
/
b
to select “By AQUOS AUDIO SP”,
and then press ENTER.
2
• The sound from the TV speaker and headphone
terminal is silenced and only the sound from the
AQUOS AUDIO speaker system is audible.
AQUOS LINK Menu
Recorder EPG
Top menu/Title list
Media change
By AQUOS AUDIO SP
By AQUOS SP
Sound mode change
Model select
Setup Menu
Open the remote control unit’s fl ip cover, and
then press OPTION.
1
Listening with the AQUOS AUDIO speaker
system
You can choose to listen to the TV sound only from
the AQUOS AUDIO speaker system.
Repeat steps 1 to 3 in AQUOS LINK control.
1
Auto power on
If this is activated, the One Touch Play function is enabled.
While the TV is in standby mode, it automatically turns on
and plays back the image from the HDMI source.
Press
a
/
b
to select “Auto power on”, and
then press ENTER.
2
Press
c
/
d
to select “On”, and then press
ENTER.
3
Press MENU to exit.
4
NOTE
• The factory default for this item is “Off”.
1
Open the remote control unit’s fl ip cover.
52D77X.indb 5152D77X.indb 51 2/17/09 5:13:40 PM2/17/09 5:13:40 PM