57
Connecting a PC
Selecting the input resolution
• Some input signals may have to be registered manually to
display properly.
• In such case, you have to set the correct signal manually.
After setting once, it will display when the same signal
(resolution) is input again.
NOTE
• You can only select the “Input signal” on the Setup menu
only when there is a necessity to set it manually.
Press MENU and the MENU screen displays.
1
Press c/d to select “Setup”.
2
Press a/b to select “Input signal” and then
press ENTER.
3
Press a/b to select the desired input signal
on the display.
4
Input resolution settings
52D77X_en_f.indd 5752D77X_en_f.indd 57 2/18/09 10:50:21 AM2/18/09 10:50:21 AM
To Next Page
Loading...
