Using external equipment
To view external source images, select the input source
from
INPUT on the remote control unit or on the
TV.
If
the image does not come
in
clearly from the external
equipment connected to INPUT 1 or
2,
you may need
to
change the input signal type setting on the "Input
Select" menu.
INPUT
FLASHBACK
o
Press MENU
to
display the MENU screen,
and then press
<OlIIIIII/~
to select "Option".
Audio Only
E>igital
Noise Reduction
[Qff]
Press MENU
to
exit.
• The setting
is
stored and can be selected on the
"INPUT SOURCE" menu.
Press
~/T
to
select the signal type you
want
to
set, and then press ENTER.
• If the selected signal type
is
Incorrect, images
are not displayed or displayed without any color.
Press
..
.IT
to
select "Input Select", and then
press
ENTER.
I_N_}j_o_p_tio_n
_
• Refer to your external equipment operation manual for the
signal type.
•
If
you set INPUT 1 or 2
to
Auto, the TV will automatically
select the input signal.
• Check the operation manual of the external equipment for
the signal type.
• Setting INPUT 1 or 2 signal selection
to
"Auto" when
other equipment
is
connected will result
in
the following
connection priority.
INPUT 1 or
2:
CD
COMPONENT VIDEO
(g)VIDEO
VOL
CH
SURROUNO{)
tJMUTE
o - v 0
-
VOL
+ v
CH
A.
INPUT
POWER
Press INPUT again
to
select the input
source.
• An image from the selected source automatically
displays.
• Each time
INPUT
is
pressed, the input source
toggles.
• You can also select the input source by pressing
./-Y.
•
If
the corresponding input
is
not plugged
in,
you
cannot change the input. Be sure to connect the
equipment beforehand.
Press INPUT.
• A list
of
selectable sources appears.
• See pages 13 to 15 for external equipment connection.
@-30
To Next Page
Loading...
