/
25
Network function
You can select "Ethernet" to connect the network.
You can add unbroadcast wireless network manually.
Enter the information about the unbroadcast wireless
network , and then select “Save”. Now the TV is
connected to the unbroadcasted wireless network.
Select the “Bluetooth” and then press OK, the TV is
scanning Bluetooth devices.
If you want to connect to the Bluetooth device, please
refer to the screen reminder.
When adjust “Wi-Fi” to “On”, it displays the nearly
wireless network.
If the current network connection security is not
open, you should enter the password from software
keyboard by pressing OK on the remote control.
You can select “Wi-Fi” to connect the network.
Ethernet network connection
Wireless network connection
Bluetooth
®
DHCP
Manual connection
Add network
System will attempt to obtain IP address and other
information automatically.
You can setup IP address, Gateway, Subnet mask,
First DNS and Second DNS following the on-screen
instructions.
Select “Setting” in the menu, and then press OK.
Press to select “Network”, and then press OK. It
displays the connect format.
Network setting
• You can press MENU to select "Network" to switch the
connection between Ethernet network connection and
Wireless network connection.
NOTE
• The Bluetooth device may not operate properly depending
on the device being used.
To Next Page
Loading...
