[11] MAINTENANCE
1. Maintenance table
✕: Check (Clean, adjust, or replace when required.) : Clean ▲: Replace : Adjust ✩: Lubricate
Section Parts 25K 50K 75K 100K 125 Remark
Developing
Developer
▲▲▲▲▲
DV blade
▲▲
DV side seal (F/R)
▲▲
Process peripheral Drum
▲▲▲▲▲
2. Maintenance display system
Toner
Life 6.5K
Remaining
quantity check ∗1
a. Press and hold the density adjustment LIGHT key for more than 5 sec, and the machine will enter the
user program mode.
b. Press and hold the "%" key for more than 5 sec, and the remaining quantity will be displayed on the
copy quantity display in one of the following levels: (Remaining quantity display levels: 100%, 75%,
50%, 25%, 10%, LO)
c. Press the density adjustment LIGHT key to cancel.
Remaining
quantity
NEAR EMPTY
About 10%
EMPTY
LED ON Flash
Machine Operation allowed Stop
Developer
Life 25K
LED ON at 25K of the developer count.
Machine
Selection is available between Not Stop and Stop by Service Simulation (SIM 26-37) Setup.
(If Stop is selected, the LED will flash and stop at 25K.)
∗ Default: Not Stop
∗ Clear: SIM 24-06
Maintenance
LED
Selection is available among 18K, 13K, 9K, 6K, 3K, and free (no lighting) with SIM 21-1.
∗ Default: free
∗ Clear: SIM 20-1
Machine Not stop.
∗1: Installation of a new toner cartridge allows to display the remaining quantity.
AR-F152
11 – 1
To Next Page
Loading...
