Sharp AR-151 - Page 66

11. DUP motor section (AR-156 only)
A. Remove the rear cabinet.
1) Remove four screws.
2) Remove the rear cabinet.
B. Remove the shield plate.
1) Remove six screws.
2) Remove the open/close detection unit, and the earth wire.
3) Remove the shield plate.
C. Remove the main PWB.
1) Remove six screws.
2) Remove connectors.
3) Remove the main PWB.
D. Remove the DUP motor.
1) Remove two screws.
2) Remove the DUP motor cover.
3) Remove the DUP motor.
Note: When reassembling, be sure to engage the DUP motor gear
with the belt on the main body side.
12. Reverse roller section (AR-156 only)
A. Remove the reverse unit.
1) Remove four screws
2) Remove the spring, and the earth wire
3) Remove the reverse unit.
B. Remove the reverse roller.
1) Bend the reverse roller and remove it.
2
1
1
1
1
2
2
3
3
1
2
2
2
2
2
2
2
1
2
3
1
1
2
3
1
AR-F152
7 – 23