Main code Sub code Content
30 01 Paper sensor status display
The paper sensor status is displayed with the lamps on the operation panel.
43 01 Fusing temperature setup (Normal copy)
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
04 Fusing temperature setup 2
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
05 Duplex mode fusing temperature setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number corresponding to the duplex and press the START key. The setting is changed
accordingly.
∗ The above shift temperature set by this simulation is added to the fusing temperature of single copy.
09 Postcard size paper fusing control setup
Display Sensor
Toner cartridge replacement lamp Paper detection before resist (PPD1)
JAM lamp Fusing section paper detection (PPD2)
Developer cartridge replacement lamp Paper exit paper detection (POD)
2nd cassette lamp 2nd CS paper detection (PPD3)
AE lamp Single manual feed paper detection (MFD)
Exposure level 1 (Light) lamp Main cassette A4 width detection (PSW1)
Exposure level 5 (Dark) lamp 2nd cassette A4 width detection (PSW2)
Code number Set temperature (˚C)
0 175
1 180
2 185
3 190
4 195 (∗ Default)
5 200
Code number Set temperature (˚C)
0 155
1 160
2 165
3 170 (∗ Default)
4 175
5 180
Code number Shift temperature (˚C)
0 ±0˚C
1 –8˚C
2 –6˚C
3 –4˚C
4 –2˚C
5 ±0˚C
6 +2˚C
7 +4˚C
8 +6˚C
9 +8˚C
Code number Setup
0 Cancel (Default)
1 Setup
AR-F152
9 – 8
To Next Page
Loading...
