Main Sub
Item Content
Adjustment
code code range
22 20 Displays printer
counter.
SIMULATION NO.22-20
PRINTER COUNTER DISPLAY
PRINTER COUNTER: XXX,XXX
[PAUSE]KEY: END DISPLAY
[Content] The current value of the printer counter is displayed.
(a) Operation/display
[PAUSE]: The execution of the simulation is stopped and the screen returns to the
sub code input screen.
[CA]: The execution of the simulation is stopped and the simulation is terminated.
23 Prints counter/
adjustment
values.
* Printing is possible only when an optional printer board is installed.
SIMULATION NO.23- _
1.COUNTER AND ADJUSTMENT VALUE PRINTING
INPUT SUB NO. AND PRESS PRINT SWITCH
[Content] The current settings of the counters and adjustment values are printed. When the
execution of the simulation is started, the copier starts warming up, and automat-
ically prints a sheet of paper. (At this time, the copier displays the copy mode
screen.) Until printing is finished, any key operation is disabled.After printing is
finished, the simulation is automatically cleared and the copier enters the usual
copy mode.
24 Clears special
counters.
SIMULATION NO.24- _
1.TOTAL JAM / JAM MEMORY CLEAR
2.TROUBLE MEMORY AND COUNTER CLEAR
3.TRAY AND ADU COUNTER CLEAR
4.RADF COUNTER CLEAR
5.STAPLE COUNTER CLEAR
7.DRUM ADJUSTMENT TIME CLEAR
8.COPY COUNTER CLEAR
9.PDA/ZR PRINT COUNTER CLEAR
12.PRINTER COUNTER CLEAR
INPUT SUB NO. AND PRESS PRINT SWITCH
9 – 38
To Next Page
Loading...
