P number
Message-related
information
Message Key input 1 Key input 2 Action Remarks
P21 P21: Sets power save mode 2-digit
number
The power save mode
time is entered in the
unit of 10 minutes
within the range from
10 ∼ 24 hours.
Initial value is
C:Cancel.
When the copier
equipped with printer
board is in the power
save mode, the LCD
goes out with the
[PRINT] key blinking.
The copier is restarted
by pressing [PRINT].
The copier
automatically starts up
when it receives print
data. If the copier
without printer board
enters the power save
mode, the power
supply is shut down.
Sets lapse time.
After entering, press [PRINT].
(C: Cancel
0:10 ∼ 24:00) X:X0
P21
When
simulations
are switched
over
P21: Sets power save mode 2-digit
number
The power save mode
time is entered in the
unit of 10 minutes
within the range of 10
minutes to 2 hours. If
the copier is left for
the preset time after
the end of copying,
the power switch is
automatically turned
off.
Factory set for 60
minutes.
No cancellation is
possible.
Set lapse time.
After entering, press [PRINT].
(0:10 ∼ 2:00) X:X0
P23 P23: Sets auto clear mode Enter auto
clear time
(10 ∼ 240)
[PRINT] Auto clear time is set. Initial value is 60. With
auto clear mode
disabled, fax memory
reception data in the
copy mode is output
240 seconds after the
copier is left.
Set auto clear time.
After entering, press [PRINT].
(101 ∼ 240 seconds. 000
disables the mode.)
P24 P24: Sets and changes
program magnification
ratio
Reduction,
enlargement
Press "REDUCTION" or
"ENLARGEMENT".
P25 P25: Sets the upper limit of
copies to be made
Enter upper
limit
(000 ∼ 999).
[PRINT] Initial value 999
Incompatible with fax
Enter the upper limit.
After entering, press [PRINT].
---
P26 P26: Sets binding allowance 1, 2, 3, 4, 5,
and 6 for
each side
Standard binding
allowance is set.
Factory set at 9 mm
for each side.
Face side Back side
Allowance Key Allowance Key
0 1 0 1
3mm 2 3mm 2
6mm 3 6mm 3
9mm 4 9mm 4
12mm 5 12mm 5
15mm 6 15mm 6
P27 P27: Sets frame deletion
width
Enter number
(0 ∼ 20).
Frame deletion width
is set.
Initial value is 5
Enter frame deletion width.
After entering, press [PRINT].
(0 ∼ 20 mm)
--
9 – 103
To Next Page
Loading...
