Sharp AR-5320 Service Manual

AR-5316/5320 USER PROGRAMS 8-2
Program name
Program
No
Description Default Parameters
Key auto repeat
25
Use this setting to select whether or not holding down a key causes
repeated input of the key. For keys that normally cause a set value to
increase when held down (for example, holding down the [ZOOM]
key), this program can be used to have the set value not change
when the key is held down.
ON
0 (OFF)
1 (ON)
Key press time
26
Use this setting to select how long a key must be pressed for the
input to be accepted. By selecting a longer time, you can prevent
settings from being changed by the accidental pressing of a key.
Minimum
(current
response
speed)
1 (Minimum
(current response speed))
2 (0.5sec)
3 (1.0sec)
4 (1.5sec)
5 (2.0sec)
Audible signals volume
27
This sets the volume of beep signals.
short beep
1 (short beep)
2 (long beep)
3 (OFF)
Base setting beep signal
28
Use this to sound a beep when a base setting is selected.
OFF
0 (OFF)
1 (ON)
Number of copies limit
29
Use this setting to select 99 or 999 for the maximum number of
copies.
999 copies
1 (99 copies)
2 (999 copies)
Use close paper size
30
When this function is enabled, printing in printer mode will
automatically continue using a different size of paper if the specified
size of paper runs out in all trays. This feature does not function in
copy mode.
OFF
0 (OFF)
1 (ON)
Default tray setting
31
Use this program to select a default tray. This tray is automatically
selected each time the power is turned on or each time the machine
reverts to the initial settings.
Upper
paper tray
1 (Upper paper tray)
2 (Lower paper tray)
5 (Bypass tray)
Default exposure mode
32
Use this program to set "AUTO", "TEXT", or "PHOTO" as the default
exposure mode.
AUTO
1 (AUTO)
2 (TEXT)
3 (PHOTO)
[08]USERPROGRAMS.fm 2 ページ ２００３年１２月１９日 金曜日 午後３時２７分

Sharp AR-5320 Specifications

General

Brand	Sharp
Model	AR-5320
Category	Copier
Language	English