100
USER SETTINGS
Resetting account
(program No.15)
The copy count of a single account or all accounts can
be reset to 0. If no account numbers have been
established, the error code "15E" will appear in the
display.
[Resetting all accounts]
Press the [1] key and then press the [START]
key ( ).
The copy counts of all accounts will be deleted.
[Resetting a single account]
1
Press the [0] key, and then press the
[START] key ( ).
2
Select the account number to be reset with
the [ZOOM] key ( ) and then press the
[START] key ( ).
Copying when "Auditing mode" is
enabled
When "Auditing mode" is enabled, "- - -" appears in the
number of copies display.
1
Enter your 3-digit account number
with the numeric keys.
When you enter your account number, "0"
appears in the number of copies display to
indicate that copying is possible.
2
Follow the appropriate steps to make
the copy.
3
When finished, press the [ ] key
().
To reset another account number, enter the
program number (15) for account number
deletion and then repeat the procedure for
"Resetting a single account".
If you enter an incorrect number, press the
[CLEAR] key ( ) and then enter the correct
number.
If you are performing an interrupt copy (p.57),
be sure to press the [INTERRUPT] key ( )
when finished to exit interrupt mode.
If a misfeed occurs or the paper runs out
during copying, your session will not end even
if the ( ) key ( ) is pressed.
To Next Page
Loading...
