Sharp AR-6020

98
USER SETTINGS
SELECTING AUDITING MODE SETTINGS
1
Hold down the [Light] key ( ) until
the alarm indicators ( , , , , )
blink.
The number of copies
display shows "- -" with
the left hyphen blinking.
2
Enter the program number with the
numeric keys.
• See "AUDITING MODE
SETTINGS" (p.97) for
the program numbers.
• The selected program
number blinks.
• For example, to select
"Auditing mode", enter
"10".
3
Press the [START] key ( ).
• The selected program
number stops blinking
and lights steadily.
• The currently selected
setting code blinks on
the right side of the
display.
4
Enter the desired setting code for the
program as explained in the detailed
procedures on the following pages.
For the setting codes, see "AUDITING MODE
SETTINGS" (p.97).
5
Press the [Light] key ( ) to complete
the settings.
The alarm indicators ( , , , , ) go off
and the display returns to the number of copies
display.
If you enter the wrong number, press the
[CLEAR] key ( ) and then enter the correct
number.
• If you enter the wrong number, press the
[CLEAR] key ( ) and return to step 2.
• If "E" (error code) blinks in the first digit of
the display, press the [CLEAR] key ( ) and
return to step 2.
Note
Note