GB-7
ENGLISH
VERTICAL AIR FLOW DIRECTION
1
Press the SWING button ( ).
• The vertical airfl ow louvre will swing.
2
Press the SWING button ( ) again
to stop the desired position.
HORIZONTAL AIR FLOW DIRECTION
1
Press the SWING button ( ).
• The horizontal airfl ow louvre will swing.
2
Press the SWING button ( ) again
to stop the desired position.
CAUTION:
Never attempt to adjust the louvres manually.
• Manual adjustment of the louvres can cause
the unit to malfunction.
• When the vertical adjustment louvre is posi-
tioned at the lowest position in the COOL or
DRY mode for an extended period of time,
condensation may result.
NOTE:
• The adjustment range is narrower the SWING
range in order to prevent condensation from
dripping.
ADJUSTING THE AIR FLOW
DIRECTION
1
2
1
2
PLASMACLUSTER OPERATION
Plasmacluster ions released into the room
will reduce some airborne mold.
1
During operation, press the PLAS-
MACLUSTER button.
• The remote control will display “ ”.
• The blue PLASMACLUSTER lamp will
light up.
TO CANCEL
Press the PLASMACLUSTER button
again.
• The blue PLASMACLUSTER lamp will
turn off.
NOTE:
• Use of the PLASMACLUSTER operation will
be memorized, and it will be activated the next
time you turn on the unit.
• To perform Plasmacluster operation in FAN
only mode, press the PLASMACLUSTER but-
ton when the unit is not operating.
The mode symbol of the remote control will go
off and the fan speed cannot be set to AUTO.
1
AY-XPC18LR_OM_ENG.indd 7AY-XPC18LR_OM_ENG.indd 7 2010-03-18 16:45:462010-03-18 16:45:46
To Next Page
Loading...
Need help?
General
