GB-12
MAINTENANCE
Be sure to stop the operation and turn off the
circuit breaker before performing any mainte-
nance.
CLEANING THE FILTERS
1. Remove the lters.
1. Lift the open panel.
2. Pull the air lters down to remove them.
2. Clean the lters.
Use a vacuum cleaner to remove dust. If the
lters are dirty, wash them with warm water
and a mild detergent. Dry lters in the shade
before reinstalling.
3. Reinstall the lters and close the open
panel.
CLEANING THE UNIT AND THE
REMOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them. It
can cause electrical shock or equipment dam-
age.
• Do not use hot water, thinner, abrasive powders
or strong solvents.
MAINTENANCE AFTER AIR
CONDITIONER SEASON
1.
Operate the unit in the FAN mode for about half a
day to allow the mechanism to thoroughly dry.
2.
Stop the operation and turn off the circuit
breaker.
3.
Clean the lters, then reinstall them.
MAINTENANCE BEFORE AIR
CONDITIONER SEASON
1. Make sure that the air lters are not dirty.
2. Make sure that nothing obstructs the air inlet or
outlet.
TIPS ON SAVING ENERGY
Below are some simple ways to save energy
when you use your air conditioner.
Set the proper temperature
• Setting too higher or lower than necessary
temperature point will result in increased power
consumption.
Block direct sunlight and prevent drafts
•
Blocking direct sunlight during cooling operation
will reduce power consumption.
• Close the windows and doors during cooling and
heating operations.
Keep lter clean to ensure the most efcient
operation
Turn off the circuit breaker when the unit is
not used for an extended period of time
• The indoor unit still consumes a small amount of
power when it is not operating.
01_AYXP9_12RMR_OM_EN.indd 12 14/08/29 16:48
To Next Page
Loading...
