GB-7
PLASMACLUSTER OPERATION
Plasmacluster ions released into the room will
reduce some airborne mold.
1
During operation, press the PLASMA-
CLUSTER button.
• “ ” will be displayed on the remote control.
• The blue PLASMACLUSTER lamp(
) will
light up.
TO CANCEL
Press the PLASMACLUSTER button
again.
• “ ” will disappear on the remote control.
• The blue PLASMACLUSTER lamp(
) will
turn off.
NOTE:
• When the unit is turned off, the use of the
PLASMACLUSTER operation will be memo-
rized, and it will be activated the next time you
turn on the unit.
• The PLASMACLUSTER ions release simultane-
ously when the fan of indoor unit operates. The
PLASMACLUSTER lamp lights up when the
PLASMACLUSTER ions release. The PLASMA-
CLUSTER lamp turns off when the fan of indoor
unit does not operate such as defrosting.
SLEEP OPERATION
The temperature setting is adjusted to prevent
the room from becoming too cold or warm, for
example while you sleep.
1
In the COOL, HEAT mode, press the
SLEEP button.
• “ ” will be displayed on the remote control.
TO CANCEL
Press the SLEEP button again.
• “ ” will disappear on the remote control.
NOTE:
• During COOL Mode
After setting the SLEEP operation at certain
temperature setting, the set temperature will
rise 1°C after each hour(maximum 3°C increase
depending on the temperature setting), and af-
ter 7 hours the set temperature will decrease
1°C and remain set at that temperature.
• During HEAT Mode
After setting the SLEEP operation at certain
temperature setting, the set temperature will de-
crease 1°C after each hour(maximum 3°C de-
crease depending on the temperature setting),
and remain set at that temperature.
• SLEEP operation is not available in AUTO, DRY
or FAN mode.
1
1
01_AYXP9_12RMR_OM_EN.indd 7 14/08/29 16:48
To Next Page
Loading...
