16
RADIO OPERATION
Tuning
1
Press the ON/STAND-BY button to turn the power
on.
2
Press the TUNER (BAND) button to select the
desired frequency band (FM ST, FM or AM).
3
Press the TUNING ( or ) button to tune into the
desired station.
Manual tuning:
Press the TUNING/TIME ( or ) button as many times as
required to adjust the frequency shown on the display to the
frequency of the desired station.
Auto tuning:
When the TUNING/TIME ( or ) button is pressed for
more than 0.5 seconds, scanning will start automatically
and the tuner will stop at the first receivable broadcast sta-
tion.
Notes:
When radio interference occurs during auto scan tuning,
auto scan tuning may stop automatically at that point.
If a weak station signal is found during auto scan tuning,
the station will be skipped.
To stop the auto tuning, press the TUNING/TIME ( or
) button again.
When an RDS (Radio Data System) station is tuned in,
the frequency will be displayed first, and then the RDS
indicator will light. Finally, the station name will appear.
4
To receive an FM stereo transmission, press the
TUNER (BAND) button so that the "ST" indicator on
the display lights up.
" " will appear when an FM broadcast is in stereo.
5
If the FM reception is weak, press the TUNER
(BAND) button so that the "ST" indicator goes out.
The reception changes to monaural, the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by
mode.
Note:
The last station tuned in will be recalled, even after
changing the tuning band or the function, or after switch-
ing the unit to the stand-by mode.
2,4,5
1
3
1
2,4,5
To Next Page
Loading...
Need help?
General
